Found a deal I couldn't pass up on and grabbed it... JMF intake manifold with a throttle body. This is gonna look badass in the engine bay.
Grabbed some new pretties
Author: lordgufi
C# developer, auto enthusiast, really bad gamer
Engine bay cleanup continued…
I thought it was over, I was wrong. The end is here for the major clean up at least though. Today I finished welding in new panels for any thing that still needed it. All that's left is to sand down some areas where I couldn't get a machine of some sort in there. All … Continue reading Engine bay cleanup continued…
Engine bay shaving… the rest
It's been a while since I posted. been busy. order of the build is taking a bit of a turn due to some life events but it's still going! Over the past couple of weeks I decided that since I blow (holes) at using the tig to try and fill holes in this engine bay … Continue reading Engine bay shaving… the rest
Engine bay shaving Part 1
Been busy with life and all that lately, took a little time off from the car for a few weeks but I'm back at it. I've gotten the engine bay cleaned up to the point that I can start welding on it without calling the fire depart me to be on stand by. There was … Continue reading Engine bay shaving Part 1
Engine bay teardown Pt 4
Things are getting a little less exciting than removing a motor but it's still progress toward the end result. today and yesterday I started pulling anything that was protruding from the cabin into the engine bay. Items such as the throttle cable, wiring harness for headlights an ac relays. None of this junk is going … Continue reading Engine bay teardown Pt 4
Engine bay teardown Pt 3
forgot to post this yesterday. I finally got the engine out of the bay. Time to start on cleaning/welding/body work soon!
Engine bay teardown Pt 2
Not a whole lot to say today other than Thanks to a fellow dsmer that dropped by today to help me get this transmission out. Again THANK YOU!
Engine bay teardown Pt1
Today... was hot... for my fat ass at least, 84 degrees and upper lower 70's for humidity. Today I began the engine bay tear down by pulling the hood off the car... not easy by yourself but i managed it without destroying anything. Time to start clearing out the engine bay. First thing i did … Continue reading Engine bay teardown Pt1
I got a little bored to day and pulled out the DA
I tried sanding some areas with 240 grit by hand to see how that would go... it didnt go, at all. tried the wire wheel on a grinder and while this got me some where I looked like a pin cushion made of steel wires. Trusty DA to the rescue 80 grit and this is … Continue reading I got a little bored to day and pulled out the DA
Every thing is better with a wing
Ok not every thing but a dsm 100% is. Otherwise it looks like a cavalier. i got kind of curious about h ow much filler the previous owner used to cover up the holes. I didn't really expect to find a 1/4 inch of it though
GufiDev.Net 